Journal cover Journal topic
Annales Geophysicae An open-access journal of the European Geosciences Union
Ann. Geophys., 27, 3179-3183, 2009
http://www.ann-geophys.net/27/3179/2009/
doi:10.5194/angeo-27-3179-2009
© Author(s) 2009. This work is distributed
under the Creative Commons Attribution 3.0 License.
 
14 Aug 2009
Influence of the ozone profile above Madrid (Spain) on Brewer estimation of ozone air mass factor
M. Antón1,2, M. López3, M. J. Costa2,4, A. Serrano1, D. Bortoli2, M. Bañón3, J. M. Vilaplana5, and A. M. Silva2,4 1Departamento de Física, Universidad de Extremadura, Badajoz, Spain
2Geophysics Centre of \'Evora (CGE), University of Évora, \'Evora, Portugal
3Agencia Estatal de Meteorología (AEMET), Madrid, Spain
4Department of Physics, University of \'Evora, \'Evora, Portugal
5Estación de Sondeos Atmosférico "El Arenosillo", Instituto Nacional de Técnica Aeroespacial (INTA), Huelva, Spain
Abstract. The methodology used by Brewer spectroradiometers to estimate the ozone column is based on differential absorption spectroscopy. This methodology employs the ozone air mass factor (AMF) to derive the total ozone column from the slant path ozone amount. For the calculating the ozone AMF, the Brewer algorithm assumes that the ozone layer is located at a fixed height of 22 km. However, for a real specific site the ozone presents a certain profile, which varies spatially and temporally depending on the latitude, altitude and dynamical conditions of the atmosphere above the site of measurements. In this sense, this work address the reliability of the mentioned assumption and analyses the influence of the ozone profiles measured above Madrid (Spain) in the ozone AMF calculations. The approximated ozone AMF used by the Brewer algorithm is compared with simulations obtained using the libRadtran radiative transfer model code. The results show an excellent agreement between the simulated and the approximated AMF values for solar zenith angle lower than 75°. In addition, the relative differences remain lower than 2% at 85°. These good results are mainly due to the fact that the altitude of the ozone layer assumed constant by the Brewer algorithm for all latitudes notably can be considered representative of the real profile of ozone above Madrid (average value of 21.7±1.8 km). The operational ozone AMF calculations for Brewer instruments are limited, in general, to SZA below 80°. Extending the usable SZA range is especially relevant for Brewer instruments located at high mid-latitudes.

Citation: Antón, M., López, M., Costa, M. J., Serrano, A., Bortoli, D., Bañón, M., Vilaplana, J. M., and Silva, A. M.: Influence of the ozone profile above Madrid (Spain) on Brewer estimation of ozone air mass factor, Ann. Geophys., 27, 3179-3183, doi:10.5194/angeo-27-3179-2009, 2009.
Publications Copernicus
Download
Share